Microwave Motion Sensor Module [AutoOn]

As AutoOn is motion detector by microwave sensor, this is electric saving device which reduce the amount of electricity as turn on and off the lamps automatically to detect human and object’s motion

Product Features

• It can be applicable to all the lamps.
  It can detect moving objects more than 20m and insensitive to dust, light, and ambient temperature etc.
• The attached CdS detects environmental light not to turn on the lamps to reduce unnecessary lighting.
• The electric instruments can be used in parallel connection if the overall power consumption of used electric instruments don’t exceed 1,100W. The case when the power consumption in more than 1,100W, an external solid state relay should be used additionally to switching the devices.
• The detection range can be adjusted according to the area of the application. The coverage can be widened unlimitedly by parallel connection of AutoOn’s.

Major characteristics

• Indoor use / compatible with various types of lights
• Hardly affected by external environmental factors, such as temperature/humidity/dust/light (accurate sensing, application in various locations and areas)
• Ability to sense all moving objects : optimized for underground parking lots
• Penetration : penetrates non-metal partition (glass, screen, plywood) to sense motion on the opposite site, optimized for toilets

Application

• Automatic light control system: toilet/hallway/stairs/entrance/underground parking lot/hall
• Security warning light, invader sensing audio
• Automatic door / escalator control
• Automatic cooling/heating control system

Specification

Sensor settings

1. First, AutoOn's switch set up to "On" after sensor front view set up to wanted main direction. 2. You have to come out from installed place after set up to 1 sec. on time, Brightness 1,500Lux, Coverage over middle for check normal operations. (If you stand on sensor front, sensor will be detect you continuously) 3. When time setting is 1 sec. you can see to turn off lamps after 1 sec. on condition of no detection. 4. After check normal operations, you must check more about dead zone(ex, toilet interior) or outside. If there are many dead zone, you must turn to right and detect on maximum. If sensor detects outside place, you must turn to left for mal-function prevention. 5. After complete coverage control, then set up time, and close control cover.

Wiring

Installation Examples

Description of detection distance

Method of wiring by SSR (Solid State Relay)