Microwave Motion Sensor Module [AutoOn Mini]

As Auto mini is motion detector by microwave sensor, this is electric saving device by turn on and off the lamps automatically to detect human and object’s motion.

Application

Automatic lamp control of stairs or hallway

Product Features

It can be applicable to all the lamps.
It can detect moving objects more than 5m and insensitive to dust, light and ambient temperature etc.
The attached CdS detects environmental light not to turn on the lamps to reduce unnecessary lighting.
It can be use any electric products within not exceed 100W.
If exceed 100W, you use SSR(Solid State Relay) switch.

Installation Pictures

AutoOn Mini Instruction

Specification of product and Control function

Item		Specification			Setting	Remark
Service voltage		Single phase 220VAC, 50~60Hz			-
Applicable lighting apparatus		All lighting apparatus operated with AC power			-
Load		100W			-	Max 300
Slide switch 1,2	Lighting time	Time1	Time2	Time	Time1 : Left Time2 : Left	1sec~5min
		Left	Left	1sec
		Right	Left	30sec
		Left	Right	1min
		Right	Right	5min
Slide swtich 3	Coverage	Left -> Maximum limit Right -> Minimum limit			Left	Max sensing range : Radius over w.5m (at height 2.5m)
Slide swtich 4	Brightness	Left -> Automatic lighting at darkness Right -> Automatic lighting at any time			Right	Darkness Condition : 10Lux
Wire		Black : Power for sensor Yellow : Power for lamp			-	4 lines
Installation		Horizontal installation on ceiling			-

Checking methods are as follows.

Initial control : Set both of the slide switch 1 (Time1) and 2(Time2) to left to be minimum time and set the slide switch (Coverage) in proper value, and then set the slide switch 4 (Brightness) to right to be lighted at any time.
Installation : Install at your desired location.
Wire connection : Connect 220VAC power to two black lines, and connect an incandescent or fluorescent lamp for testing to a pare of yellow lines.
Wait for 5 seconds after turn on power. (Normal sensing begins after 5 seconds from turn on power)
Checking the sensing range : Check the sensing range by the flickering status of the lighting apparatus as actual movement. Adjust the location of any problem in location and adjust the slide switch 3 (Coverage) if the sensitivity is excessive of short.
Selection of brightness for sensing : Determine whether automatic lighting regardless of brightness or automatic lighting only at darkness by adjusting the slide switch4.
Set the desirable light time by adjusting the slide switch 1 (Time 1) and the slide switch 2 (Time2). Recommendable time is generally 1 minute, and especially for a fluorescent lamp, it is generally economical to prevent rapid reduction of life by unnecessary flickering.

Drawing for wire connection

Microwave Motion Sensor Module [AutoOn Mini]

Korea

TMSM200-100